COM flag not set
Hi,
when I try to start communication in CIFX50 CO in CANOpen, i always see the same error message: "COM flag not set".
I send the actual firmware to the card, I desconnect all the slave, but the error it is the same.
What can I do??
Yes, all of that it is ok.
I configure all bus and master parameters in sycon.net and next I download it to the card.
Andreas Jacob
Hilscher Gesellschaft fuer Systemautomation mbH
Please check in Sycon.Net all the different diagnostics. Maybe there is an error.
I only see that in firmware diagnostic:
Task CANOPEN_MASTER State "Task is not communication"
I configure all bus parameters, card parameters and I dont have now any slave. I only try to start comunication in the card.
Andreas Jacob
Hilscher Gesellschaft fuer Systemautomation mbH
:lol: Ok, that's it.
As long there is no slave connected you will not get the Com flag.
But if I connect a slave, I have the same error......
Can I do "Automatic Network scan" like in old software??
Andreas Jacob
Hilscher Gesellschaft fuer Systemautomation mbH
I am not sure if the aut network scan is supported in your version.
My version is Sycon.net for netx 1.104 (Build 90622)
Exists a new version??
Andreas Jacob
Hilscher Gesellschaft fuer Systemautomation mbH
I am not sure, please get in contact with the hotline from Hilscher. They are able to clarify the version numbers and your problem.
Andreas Jacob
Hilscher Gesellschaft fuer Systemautomation mbH
Hi,
please check if you have configured your network with Sycon.Net and you have downloaded the configuration.