Hi,
I try to understand the UART Printf demoproject.
Then I start HiTop, load this project and download it in my NXHX demoboard.
After I click on Go(F5) I can see with a sniffer, that some bytes were sended.
But I can stop the stop the debugging and reset, but I can´t restart it.
The demoboard don´t send the bytes again. Only with closing HiTop and start from beginning it works once again.
I think it´s a simply fault by my self, but I don´t know where it is ;)
I think I found my problem. I clicked on "Reset Registers" and "Reset". "Rest Registers" should be enough ;)