Config the 2ndStageBootloader with Tag list editor
Hi
We want to connect our NXHX 500-RE with an AVR ATXMEGA128 via EBI. In the netX design guide wie found (chapter 3.7.3.2 , figure 24) the 8 Bit multiplexed Mode.
Now we want to config the 2ndStageBootloader with the tag list editor for the 8 bit multiplexed Mode.
My Questions:
Which one of the registers do we have to change for the chosen mode (IF_CONF0, IF_CONF1, O_REGMODE0, IO_REGMODE1)?
Do we only have to change IF_CONF0?
Does anyone know the right config for the registers?
Thx
Hi Adreas,
Where can I download the TagListEditor.exe.
Vincent
Andreas Jacob
| 19.01.2012 | 06:15
Andreas Jacob
Hilscher Gesellschaft fuer Systemautomation mbH
Hello Vincent,
it is part of the cifX DVD from Hilscher.
Regards
AJ
Andreas Jacob
Hilscher Gesellschaft fuer Systemautomation mbH
Hi,
as you can see in the 2nd Stage Bootloader manual you need to set all these registers (IF_CONF0, IF_CONF1, O_REGMODE0, IO_REGMODE1).
To figure out the needed values I would suggest the Hilscher netX Register Creator Tool. You can download it on the Hilscher page or by following this link.
This tool should be easy to use and will provide at the end the needed HEX values.
Regards
AJ